Today is 2021-03-01 Monday,Welcome to this site 

FAQ

Common problems

Part of the automatic glass cutting machine

Word:[Big][Middle][Small] QR Code 2017/3/20     Viewed:    


General by fully automatic glass cutting machine cutting table, cutting bridge and computer control box three some. Was sent by bracket, desktop, cutting table, belt and transmission equipment, air cushion, etc. Bracket is used to support the desktop, it consists of steel column, steel beam etc. Desktop made from laminated plates, there are 3-6 ship longitudinal arrangement, in which the belt transport outside of the desktop are paved with felt.

Desktop has many holes, holes are connected to the air cushion bellows, carrying on appearance usually slightly below the blanket surface. Delivery of glass, after lifting equipment to raise its, their appearance is slightly higher than the surface of carpets, transport belt transmission equipment and lifting devices are installed in the bottom desktop, air cushion devices composed of bellows, duct, fan, etc.

Cut glass, a fan, open duct damper, using a fan blowing into the bellows, bellows inside the air hole overflow from the surface of the table and the formation of air cushion, glass lifts, in order to adjust the position of the glass and avoid scratching the glass appearance, closed duct damper when cutting glass, glass on the table.

Automatic glass cutting bridge cutting machine, cutting bridge is a bridge spans the metal structure cutting table is empty, it supports on the cutting table of longitudinal lateral metal rail. Next to the guide rail of the equipment are cutting start and cutting knife wheel, glass cutter wheel of raw material is tungsten carbide, it is installed on an axis, the shaft installed in the cylinder piston rod end, shaft and cylinder are equipment for cutting the beginning.

Computer control box, computer control box is converged on equipment, the operation of the automatic control cabinet. Operation, only need through the keyboard to the number of cut glass, standard, such as the shape data input computer, cutting machine cutting operation in accordance with the completion of computer instruction.

Go Back
Print
[Upward]